How to Make Cork Case for Earpods
Why should you carry around your earpods in a case that everyone has?
Time to be original and create your own using natural and sustainable materials. Grab a few natural cork fabrics and get started:
- measure your EarPods and note them down;
- cut three panels according to your measurements;

- soak your panes in water for 10 mins;

- pat dry them with a towel;

- cover your EarPods case for safety;

- with the help of small paper clips place the damp cork fabric panels on the case and clip them as shown;

- clip all 4 sides and let it set for 3-4 hours;

- remove all the clips and your mould is now ready (soaking for too long may result is chipping brown aware);

- keep two flat magnets to make the closure;

- stick the three moulded panels as shown;

- now mark your edges to stitch them;

- cut out the top portion as shown;

- place your case inside and check the height of the opening;

- mark the excess and cut it out;

- now place the case inside and check the fit;

- mark the charge socket at the bottom and cut it out neatly;

- glue the front two panels along with the one magnet;

- stitch the three sides as shown;

- now cut out the excess fabric;

- make a small flap to complete the case along with the other magnet;

- cut 2 pieces of the flap;

- stitch two square pieces together with the magnet then trace the flap pattern and cut it;

- now stitch along the corner of the flap;

- make sure you can place a hook at the back of the flap;

- neatly apply bond solution on the edges as shown and let it dry;

- similarly apply the bond solution on the flap as well;

- prepare the edge color and apply it once the bond solution is dry;

- when the two half’s are dry hand sew the open end along with the hook;

A cute cork case is now ready
Leave a comment