How to Make Cork Case for Earpods

• measure your EarPods and note them down;

• cut three panels according to your measurements;

• soak your panes in water for 10 mins;

• pat dry them with a towel;

• cover your EarPods case for safety;

• with the help of small paper clips place the damp cork fabric panels on the case and clip them as shown;

• clip all 4 sides and let it set for 3-4 hours;

• remove all the clips and your mould is now ready (soaking for too long may result is chipping brown aware);

• keep two flat magnets to make the closure;

• stick the three moulded panels as shown;

• now mark your edges to stitch them;

• cut out the top portion as shown;

• place your case inside and check the height of the opening;

• mark the excess and cut it out;

• now place the case inside and check the fit;

• mark the charge socket at the bottom and cut it out neatly;

• glue the front two panels along with the one magnet;

• stitch the three sides as shown;

• now cut out the excess fabric;

• make a small flap to complete the case along with the other magnet;

• cut 2 pieces of the flap;

• stitch two square pieces together with the magnet then trace the flap pattern and cut it;

• now stitch along the corner of the flap;

• make sure you can place a hook at the back of the flap;

• neatly apply bond solution on the edges as shown and let it dry;

• similarly apply the bond solution on the flap as well;

• prepare the edge color and apply it once the bond solution is dry;

• when the two half’s are dry hand sew the open end along with the hook;

A cute cork case is now ready